Hooked up a EVO-CHRT5 kit to a 2006 Dodge RAM SRT-10 as standalone, ran into two issues.
First, following the install guide I used connection 'F'. However there wasn't a green/yellow starter wire so I moved to connection 'C' as the guide instructed. On further inspection, the plug inside the SRT-10 with the 12v, IGN, and MUX wires is different than the one pictured in the guide, as well it has 6 pins instead of 5. Is there a different guide for the SRT-10 or is it not compatible?
Second, after following connection 'C', the EVO-ALL programmed normally. Option 15 was set to Standalone Mode before installation with the Flashlink Updater. However, when I hit LOCK 3x the car does not start. The RED LED on the EVO-ALL comes on, followed by the YELLOW, then the BLUE flashes extremely fast. The truck does nothing during this, no ignition, nothing.
I have tried Firmware 4.09, 4.18, and the recommended one as well. Same results for all of them. Any help would be greatly appreciated!
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
